As an Amazon Associate I earn from qualifying purchases.
JZK #ad - The device is available in a sot23 package to provide small, laptops, low-cost solutions for digital current sensing of servers, battery management, power supplies, and automotive and telecom equipment.
The high precision of the product combines the advantages of 12-bit resolution to help customers minimize the pressure on the shunt resistor, thus minimizing power loss and power consumption and saving board space.
The i2c interface has a timeout setting that not only prevents bus lockout, but also provides high-speed mode for up to 3. 4 mhz communication requirements. The ina219 achieves a maximum error accuracy of 1% over the -40 ° C to + 85 ° C temperature range with a maximum offset of 100 uV.
bayite #ad - Electrically isolated from high voltage power source which eliminates risk to delicate monitoring equipment and also minimizes safety concerns.
Compatible with large wire; Diameter of the hole through sensor is 3/4 inch19 mm. For example, if your current signal is only 02 amps, you could loop the wire through the sensor 10 times and the signal would by 10X stronger and would appear as 2.
MakerFocus #ad - How to use the gps module better, the link is obtained in the Product guides and documents, please download it before use. When using it, please make sure that the GPS module is in an open location. Note: this gps module will not search for signals when the weather is bad, and it will not search for stars indoors.
Gt-u7 module, low power consumption, miniaturization, its extremely high tracking sensitivity greatly expanded its positioning of the coverage.
Usb directly connected to the computer, with the host computer-owned serial port function, no need for external serial module, That is, send IPX interface active antenna!. With a usb interface, you can directly use the phone data cable on the computer point of view positioning effect; With IPEX antenna interface, the default distribution of active antenna, can be quickly positioned.
DAOKI #ad - Note:antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, and interference source; frequency used to receive, high pressure, decode and oscillation resistor should match with the transmitter.
Great influence on the antenna module reception, typically 50 ohm single conductor, preferably connected to the 1/4 wavelength of the antenna, the length of the antenna 433M of about 17cm;.
KAIWEETS #ad - Aftersales - kaiweets provides a 36-month after-sale service, lifetime technical support. Double insulated unit. Anti-burn with double ceramic fuse and thermistor protection circuit. Silicone protective case prevents it from falling damage.
Wide applications - kaiweets ht118a multimeter measures up to 600v ac/dc voltage, 10A AC/DC current and 60 MOhms resistance, duty-cycle, electrical tester also tests temperature, capacitance, frequency, wire on-off, and test diodes and continuity.
To plug in the leads is easy. Stable kickstand, data retention, Pen slot on the back, Low battery prompt, Auto power-off. High voltage Protection is active on all ranges. Easy operation - switch the dial to the function you need, and the led lights on the jacks will shine accordingly. Multi-function - non-contact voltage testing and live function with sound and light alarm.
MOBILETRON #ad - Relearn ready : our preprogrammed tire sensor comes ready to be paired to compatible vehicle, please use Amazon Part Finder to verify the fitment.
What is relearn : all new sensors are required relearn procedure to pair with vehicle, please refer to your owner's manual for standard relearn instruction. Excellent signal strength : Fits all types of passenger vehicle, proven to work on custom size wheel and tire.
Beffkkip #ad - Trigger mode: low level trigger ground. The first time the load is connected, the output will be automatically turned off after 30 seconds; if the load is greater than 50MA, the output is automatically turned on.
Lithium battery protection function: over-current, over-temperature, overvoltage, short circuit protection. If the load is less than 50MA, the output will be automatically turned on. 4 in 1 charging + discharging + lithium battery Protection + Battery Level Indicator Module.
NewZoll #ad - Pin 5v power supply, on-board power indicator. Product name : acs712 current Sensor Module;Working Power : 5V. Output : 100mV/A. Size : 31 x 13mm. 30a range current Sensor Module.
ACDelco #ad - Professional, premium aftermarket replacement. Manufactured to meet expectations for fit, form, and function. Color-coded wires allow for easy installation. Protective outer coverings provide long-lasting durability. Fit type: Vehicle Specific.
Walfront #ad - Widely application: hysteresis is less than 1% and can be used under strong magnetic conditions. Straight-through structure design, isolation withstand voltage up to 2000V.
Safe security: mutual inductance current monitoring has high current detection accuracy and safe isolation of input and output. Suitable for ac current measurement and monitoring, AC motor overload protection, electronic switch of automatic control system and so on.
1. JZK
#adJZK CJMCU-219 INA219 I2C Interface Bidirectional DC Current/Power Monitoring Sensor Module for Arduino Raspberry Pi
#adThe high precision of the product combines the advantages of 12-bit resolution to help customers minimize the pressure on the shunt resistor, thus minimizing power loss and power consumption and saving board space.
More information #ad
The ina219 offers the industry's highest accuracy and smallest size, to sense the shunt supply voltage, not only to monitor the pressure on the shunt resistor, but also to calculate the power supply. The i2c interface has a timeout setting that not only prevents bus lockout, but also provides high-speed mode for up to 3. 4 mhz communication requirements. The ina219 achieves a maximum error accuracy of 1% over the -40 ° C to + 85 ° C temperature range with a maximum offset of 100 uV.
| Brand | JZK #ad |
| Manufacturer | JZK #ad |
| Height | 2.36 Inches |
| Length | 9.06 Inches |
| Width | 6.3 Inches |
| Part Number | JZK |
| Model | JZK |
More information #ad
2. bayite
#adBayite DC 5-120V 400A Mini Digital Current Voltage Amp Meter Gauge with Hall Effect Sensor Transformer
#adCompatible with large wire; Diameter of the hole through sensor is 3/4 inch19 mm. For example, if your current signal is only 02 amps, you could loop the wire through the sensor 10 times and the signal would by 10X stronger and would appear as 2.
More information #ad
0 amps. Display voltage or + -current; voltage Range: 5V-120V; Current range: 0-400A. Through-hole design: easy Wiring; Measure positive or negative current; No current direction limitation. Loop through sensor multiple times to strengthen signal.| Brand | bayite #ad |
| Manufacturer | bayite #ad |
| Weight | 0.17 Pounds |
| Part Number | BYT-VAM-035 |
More information #ad
3. MakerFocus
#adGPS Module GPS NEO-6MAr duino GPS, Drone Microcontroller GPS Receiver Compatible with 51 Microcontroller STM32 Ar duino UNO R3 with IPEX Antenna High Sensitivity for Navigation Satellite Positioning
#adGt-u7 module, low power consumption, miniaturization, its extremely high tracking sensitivity greatly expanded its positioning of the coverage.
More information #ad
Gpsbaud needs to be set to 9600 instead of 4800; pps pin is not needed unless using the gps to drive a hardware high precision clock; GT-U7 main module GPS module using the original UBLOX 7th generation chip, with high sensitivity, Software is compatible with NEO-6M. Usb directly connected to the computer, with the host computer-owned serial port function, no need for external serial module, That is, send IPX interface active antenna!. With a usb interface, you can directly use the phone data cable on the computer point of view positioning effect; With IPEX antenna interface, the default distribution of active antenna, can be quickly positioned.
| Brand | MakerFocus #ad |
| Manufacturer | MakerFocus #ad |
| Height | 0.39 Inches |
| Length | 1.09 Inches |
| Weight | 0.02 Pounds |
| Width | 3.94 Inches |
| Part Number | SN12SF83QOH11452IC |
| Model | SN12SF83QOH11452IC |
More information #ad
4. DAOKI
#adDAOKI 5 Set 433MHz RF Transmitter and Receiver Wireless Module Kit High Frequency Remote Control for Arduino with 433MHz Antenna
#adGreat influence on the antenna module reception, typically 50 ohm single conductor, preferably connected to the 1/4 wavelength of the antenna, the length of the antenna 433M of about 17cm;.
More information #ad
Widely use for remote control rolling gates, remote control LED, remote control MP3, remote control audio, smart car, smart home, etc. Package content:5 x 433mhz rf wireless Transmitter Module and Receiver, 10 x 433MHZ Antenna.| Brand | DAOKI #ad |
| Manufacturer | DAOKI #ad |
| Weight | 0.22 Pounds |
| Part Number | DR-US-329 |
| Model | DR-US-329 |
More information #ad
5. KAIWEETS
#adKAIWEETS Digital Multimeter TRMS 6000 Counts Voltmeter Auto-Ranging Fast Accurately Measures Voltage Current Amp Resistance Diodes Continuity Duty-Cycle Capacitance Temperature for Automotive
#adWide applications - kaiweets ht118a multimeter measures up to 600v ac/dc voltage, 10A AC/DC current and 60 MOhms resistance, duty-cycle, electrical tester also tests temperature, capacitance, frequency, wire on-off, and test diodes and continuity.
More information #ad
Package includes multimeter, test leads, thermocouple, batteries and user manual. Min/max/average to record signal fluctuations. Note: please take off the cap before using the leads. Large 2. 9” lcd backlight display, easy-to-read digits offer a 6000-count resolution. To plug in the leads is easy. Stable kickstand, data retention, Pen slot on the back, Low battery prompt, Auto power-off. High voltage Protection is active on all ranges. Easy operation - switch the dial to the function you need, and the led lights on the jacks will shine accordingly. Multi-function - non-contact voltage testing and live function with sound and light alarm.
| Brand | KAIWEETS #ad |
| Manufacturer | KAIWEETS #ad |
| Height | 2.17 Inches |
| Length | 7.48 Inches |
| Width | 3.54 Inches |
| Part Number | KW8022930 |
| Model | HT118A |
More information #ad
6. MOBILETRON
#adMORESENSOR Signature Series 315MHz TPMS Tire Pressure Sensor 4-Pack | Preprogrammed for Select 25+ Japanese Brand Models | Replacement for 42753-STK-A04 | Clamp-in | NX-S072-4
#adWhat is relearn : all new sensors are required relearn procedure to pair with vehicle, please refer to your owner's manual for standard relearn instruction. Excellent signal strength : Fits all types of passenger vehicle, proven to work on custom size wheel and tire.
More information #ad
You are covered : moresensor singature Series comes with 3 Year limited warranty, please contact us for more information. Solid quality : the average lifespan battery life of our sensor is 5-8 years, as well as all the other electronic and mechincal components.| Brand | MOBILETRON #ad |
| Manufacturer | MOBILETRON ELECTRONICS #ad |
| Height | 1 Inches |
| Length | 3 Inches |
| Width | 2 Inches |
| Part Number | CX-S072-4 |
More information #ad
7. Beffkkip
#adBeffkkip 4pcs 2A 5V Charge Discharge Integrated Module 3.7V/4.2V PCB Board Module for 18650 Lithium Battery Charging Boosting Mobile Power Board
#adLithium battery protection function: over-current, over-temperature, overvoltage, short circuit protection. If the load is less than 50MA, the output will be automatically turned on. 4 in 1 charging + discharging + lithium battery Protection + Battery Level Indicator Module.
More information #ad
Note: at this time output voltage 4. 7 / 5v. Allow discharge while charging. In discharge mode the charging mode key function is invalid, trigger the KEY port once to open the output; continuously trigger the KEY port twice to close the output. Mcu users, if you accept a small load key can be connected to the microcontroller about 20s to provide a low level allows the module to continue working.| Brand | Beffkkip #ad |
| Manufacturer | Deegoo-FPV #ad |
| Weight | 0.02 Pounds |
More information #ad
8. NewZoll
#ad2 X 30A Range Current Sensor ACS712 Module
#adMore information #ad
| Brand | NewZoll #ad |
| Manufacturer | NewZoll #ad |
| Height | 0.39 Inches |
| Length | 0.39 Inches |
| Weight | 0.07 Pounds |
| Width | 0.39 Inches |
| Part Number | 43237-2 |
More information #ad
9. ACDelco
#adACDelco Professional PT2315 Multi Purpose Wire Connector with Leads
#adMore information #ad
| Brand | ACDelco #ad |
| Manufacturer | ACDelco #ad |
| Height | 2.2 Inches |
| Length | 4.3 Inches |
| Width | 2.4 Inches |
| Part Number | PT2315 |
| Model | PT2315 |
| Warranty | 24 Month / Unlimited Mile Limited Warranty on parts sold on or after 04/01/18. (Parts Only) Please see ACDelco.com for more details. |
More information #ad
10. Walfront
#adAC Current Transducer Transmitter Transformer Sensor AC Current Converter AC 0-50A to DC 0-5V SZT15-CH-5V
#adSafe security: mutual inductance current monitoring has high current detection accuracy and safe isolation of input and output. Suitable for ac current measurement and monitoring, AC motor overload protection, electronic switch of automatic control system and so on.
More information #ad
Easy to use: easy to install and use, no need to connect DC into the circuit when measuring. Product specification: self-powered, no external power supply required. Measured current ac 0-10/20/50A, output signal DC 0-5V. High quality：the outer casing is made of self-extinguishing material ABS.| Brand | Walfront #ad |
| Manufacturer | Walfront #ad |
| Height | 0.98 Inches |
| Length | 3.54 Inches |
| Weight | 0.22 Pounds |
| Width | 2.56 Inches |
| Part Number | Wal front7vf6ob5ype |
More information #ad
